Qos Dscp-Color-Map - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

Dell(conf-dscp-color-map)# dscp yellow 9,10,11,13,15,16

qos dscp-color-map

qos dscp-color-map

Configure the DSCP color map.

qos dscp-color-map map-name

To remove a color map, use the no qos dscp-color-map map-name command.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

A color map outlines the codepoint mappings to the appropriate color mapping

(green, yellow, red) for the traffic. The system uses this information use to handle

the traffic on the interface based on the traffic priority and places it into the

appropriate shaping queue. You cannot delete a DSCP color map when it is

configured on an interface. If you do, all the DSCP values are set to green (low

drop precedence). To delete the DSCP color map that is being used by one or

more interfaces, remove the DSCP map from each interface.

Quality of Service (QoS)

A DSCP value cannot be in both the yellow and red lists. Setting the red or

yellow list with any DSCP value that is already in the other list results in an error

and no update to that list is made.

Each color map can only have one list of DSCP values for each color; any DSCP

values previously listed for that color that are not in the new DSCP list are

colored green.

— configures the DSCP color map

dscp-color-policy— configures a DSCP color policy

Enter the name of the DSCP color map. The map name can

have a maximum of 32 characters.

Introduced on the Z9500.

Introduced on the Z9000, S6000, S4820T, S4810, and MXL.