Vrrp Delay Minimum - Dell Force10 S4810P Reference Manual

Parameters
ip-address1
... ip-address12
Defaults Not configured.
Command Modes VRRP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
pre-Version
6.2.1.1
Usage
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is
Information
configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual
address with the same IP address as the interface's primary IP address and change the priority
of the VRRP group to 255.
You can ping the virtual addresses configured in all VRRP groups.

vrrp delay minimum

Set the delay time for VRRP initialization after an interface comes up.
Z-Series, S4810
Syntax vrrp delay minimum seconds
Parameters
seconds
Defaults 0
Command Modes INTERFACE
Command History
Version 9.0.0.0
1624
Enter an IP address of the virtual router in dotted decimal format. The
IP address must be on the same subnet as the interface's primary IP
address.
(OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in
dotted decimal format. Separate the IP addresses with a space. The
IP addresses must be on the same subnet as the interface's primary
IP address.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced support for telnetting to the VRRP group IP address
assigned using this command.
Introduced on the E-Series.
Enter the number of seconds for the delay for VRRP initialization after
an interface becomes operational. The range is 0 to 900 (0 indicates
no delay).
Introduced on the Z9000.