Assembly Of Transmission - Toyota 4-Runner 1985 Repair Manual

AUTOMATIC TRANSMISSION - Assembly of Transmission
AT-93
ASSEMBLY OF TRANSMISSION
;assembly, inspection and assembly of each com-
ponent group have been indicated in the preceding
chapter. Before assembly, make sure again that all
component groups are assembled correctly.
GENERAL ASSEMBLY NOTES:
1. The automatic transmission is composed of
highly precision-finished parts, necessitating
careful inspection before assembly because
even a small nick could cause fluid leakage or
affect performance.
2. Before assembling new clutch discs, soak
them in automatic transmission fluid for at
least two hours.
3. Apply automatic transmission fluid on sliding
or rotating surfaces of the parts before
assembly.
4. Use petroleum jelly to keep the small parts in
their places.
A
B
c
Front
D
If something wrong is found in a certain component
group while assembly, inspect and repair this group
immediately.
5. Do not use adhesive cements on gaskets and
similar parts.
6. When assembling the transmission, be sure to
use new gaskets and O-rings.
7. Dry all parts by blowing with compressed air.
Never use shop rags.
8. Be sure to install the thrust bearings and races
in the correct direction and position.
E
F
G
H
AT0015