Toyota 4-Runner 1985 Repair Manual page 360

MANUAL TRANSMISSION - W46, 55 and 56 Transmission
MT-29
WM0137
WM0140
(d) Install the 5th gear assembly with the synchronizer
ring slots aligned with the shifting keys.
20. (5-Speed)
INSTALL SPACER AND BEARING
(a) Install the spacer.
(b) Install the bearing with the ball shield toward the rear.
(c) Using a hammer and socket wrench, drive in the
bearing.
NOTE: When driving in the bearing, support the counter-
shaft in front with a 3-5 Ib hammer or equivalent.
21. (5-Speed)
INSTALL SNAP RING
Select a snap ring that will allow minimum axial play and
install it on the shaft.
Mark Thickness
mm (in.)
Mark
Thickness
mm (in.)
1 1.90-1.95 (0.0748-0.0768) 5 2.14-2.19 (0.0843-0.0862)
2 1.96-2.01 (0.0772-0.0791) 6 2.20-2.25 (0.0866-0.0886)
3
2.02- 2.07 (0.0795-0.0815) 7 2.26-2.31 (0.0890-0.0909)
4 2.08-2.13 (0.0819-0.0839)
22. INSTALL SPEEDOMETER DRIVE GEAR
(a) Put a clip on the output shaft and install the drive gear
clip into the slot.
(b) Slide the drive gear with clip and fit the clip into the
holes.
23.-1 (4-Speed)
INSTALL SHIFT FORKS, SHIFT FORK SHAFTS AND
REVERSE IDLER GEAR
(a) Install the reverse shift arm and shift fork shaft No.3.
(1) Put the reverse shift arm into the pivot of the
bearing retainer and install shift fork shaft No.
3 to the intermediate plate.