Toyota 4-Runner 1985 Repair Manual page 440

AT-38
AUTOMATIC TRANSMISSION - Component Groups (Oil Pump)
SST
o
AT0003
ASSEMBLY OF OIL PUMP
(See page AT-36)
1 . INSTALL DRIVEN GEAR AND DRIVE GEAR AND SET PO"' ...
2.
3.
4.
BODY ON TORQUE CONVERTER
Make sure the tops of the gears are facing up ward.
LOOSELY INSTALL PUMP COVER
Align the bolt holes and drop the pump cover into place.
Install the six bolts with wave washers finger tight.
ALIGN PUMP BODY AND PUMP COVER
Install the SST around the body and cover.
Tighten SST to align the body and cover.
SST 09350-20013
TIGHTEN SIX PUMP COVER BOLTS
Torque: 75 kg-em (65 in.-Ib, 7.4 N·m)
5. REMOVE SST
6. INSTALL TWO OIL SEAL RINGS ON PUMP COVER
Spread apart and slide them into the groove.
Hook both ends by hand.
Wipe off excess petroleum jelly.
7. INSTALL NEW O-RING ON PUMP
Make sure the a-ring is not twisted and is fully seated in
the groove.
8. CHECK DRIVE GEAR ROTATION
Turn the drive gear with a screwdriver and make sure it
rotates smoothly.
CAUTION: Do not damage the oil seal lip.