Toyota 4-Runner 1985 Repair Manual page 422

AT-20 AUTOMATIC TRANSMISSION - On-Vehicle Repair
OROOll
OR0010
AT0762
4. INSTALL VALVE BODY BOLTS
Install the bolts as shown. Tighten the bolts evenly.
NOTE: Each bolt length (mm) is indicated in the figu, _
Torque: 100 kg-em (7 ft-Ib, 10 N -m)
5. INSTALL GASKET AND OIL STRAINER
(a) Install the gasket.
(b) Be sure the strainer is clean. Torque the bolts.
Torque: 55 kg-em (48 in.-Ib, 5.4 N -m)
6. INSTALL OIL TUBES
Press the tubes by hand into the positions indicated in the
figure.
7. INSTALL PAN WITH NEW GASKET
Be sure the pan is clean and the magnet is in place.
CAUTION: Do not use gasket sealer.
Tighten the bolts evenly.
Torque: 45 kg-em (39 in.-Ib, 4.4 N -m)
8. INSTALL DRAIN PLUG
Torque the drain plug.
Torque: 205 kg-em (15 ft-Ib, 20 N -m)
9. FILL TRANSMISSION WITH ATF
Add only about four liters of ATF.
Fluid type: ATF DEXRON 1I
CAUTION: Do not overfill.
10. CHECK FLUID LEVEL (See page MA-19)