Toyota 4-Runner 1985 Repair Manual page 299

ST-4
\
STARTING SYSTEM - Starter
REMOVAL OF STARTER
1. DISCONNECT CABLE FROM NEGATIVE TERMINAL
BETTERY
2. REMOVE TRANSMISSION OIL FILLER TUBE (AfT only)
3. DISCONNECT TWO WIRES FROM STARTER
Remove the nut and disconnect the battery cable from the
magnetic switch on the starter motor. Disconnect the other
ST0004
wire from terminal 50.
STOOOS
ST0006
ST0007
STOOO8
4. REMOVE STARTER MOTOR
Remove the two bolts, and remove the starter motor from
the flywheel bellhousing.
DISASSEMBLY OF STARTER
(See page ST -3)
1. REMOVE FIELD FRAME WITH ARMATURE FROM
MAGNETIC SWITCH ASSEMBLY
(a) Disconnect the lead wire from the magnetic switch
terminal.
(b) Remove the two through bolts. Pull out the field frame
with the armature from the magnetic switch assembly.
(c) Remove the felt seal. (1.0 kW type only)
(d) Remove the O-ring. (1.4 kW type only)
2. REMOVE STARTER HOUSING FROM MAGNETIC
SWITCH ASSEMBLY
[1.0 kW type)
Remove the two screws and remove the starter housing
with the idler gear and clutch assembly.
[1.4 kW type]
Remove the two screws and remove the starter housing
with the pinion gear, idler gear and clutch assembly.