Toyota 4-Runner 1985 Repair Manual page 452

AT-50 AUTOMATIC TRANSMISSION - Component Groups (Front Clutch)
' . 7. INSTALL THINNER SNAP RING IN CLUTCH DRUM
(a) Remove the snap ring, rear clutch hub and one
di~"
to allow installation of the inner shap ring.
(b) Compress and lower the snap ring into the groove by
hand. Check that the ends of the snap ring are not
aligned with one of the cutouts.
8. INSTALL DISC
9. INSTALL INNER THRUST BEARING AND RACES
IMPORTANT: Coat parts with petroleum jelly to keep
them in place.
Install the inner race, needle bearing and outer race. Press
them into place.
NOTE: Face the lip of race toward the front clutch body.
10. INSTALL FRONT CLUTCH HUB
Align the disc lugs with the hub teeth. Make sure the hub
meshes with all the discs and is fully inserted.
11. INSTALL REAR CLUTCH HUB AND OUTER SNAP RING
Check that the snap ring ends are not aligned with one the
cutouts.
NOTE: Note the position of the thrust bearing and races,
and keep them together until assembly.
12. KEEP THRUST BEARINGS AND RACES TOGETHER