Toyota 4-Runner 1985 Repair Manual page 498

AT-96 AUTOMATIC TRANSMISSION - Assembly of Transmission
,.:
iIIIf
!
·E!lSL.
12. INSTALL THRUST BEARING RACE OVER SPUNED END OF
REAR CLUTCH IN CASE
Coat parts with petroleum jelly to keep them in place. p(
tion the lip of the race toward the rear clutch.
13. INSTALL THRUST BEARING AND RACE ON FRONT
CLUTCH
Coat parts with petroleum jelly to keep them in the place.
Position the lip of the race outward.
14. INSTALL FRONT CLUTCH ASSEMBLY IN CASE
Align flukes of the rear clutch discs and mesh them with
the front clutch hub. Push the front clutch assembly into
the case.
CAUTION: Be careful that the thrust bearing does not fall
out.
15. CHECK CORRECT INSTALLATION OF FRONT CLUTCH
Set SST on the transmission case as shown in the figure.
Mesure the distance between the top surface of SST and
front clutch assembly. If the distance corresponds to that
during disassembly
I
the front clutch is installed correctly.
SST 09350-20013
Height: Measured value minus SST width
=
Approx. 2 mm (0.08 in.)
16. INSTALL SST ON CASE
Finger tighten the SST on the transmission case.
SST 09350-20013
17 . INSTALL THRUST BEARING ON FRONT CLUTCH
Coat the thrust bearing with petroleum jelly and set it i'
place.