Toyota 4-Runner 1985 Repair Manual page 511

TF-4
MTOO22
TF0105
TRANSFER -
Transfer
9. REMOVE CLUTCH RELEASE CYLINDER, TUBE BRACKET
AND STARTER LOWER MOUNTING BOLT
Remove the mounting bolts and lay the starter and relea
cylinder alongside the engine.
NOTE: Do not disconnect the clutch line.
10. REMOVE FRAME CROSSMEMBER NO.2 FROM SIDE
FRAME
(a) Remove the four bolts from the engine rear mounting.
(b) Raise the transmission slightly with a jack.
(c) Remove the four bolts from the side frame and remove
the frame crossmember No.2.
11. PLACE PIECE OF WOOD BETWEEN ENGINE OIL PAN AND
FRONT AXLE
12. LOWER TRANSMISSION WITH TRANSFER
13. REMOVE EXHAUST PIPE BRACKET AND STIFFENER
PLATE BOLTS
14. REMOVE REMAINING TRANSMISSION BOLTS
15. REMOVE TRANSMISSION WITH TRANSFER
(a) Draw out the transmission with the transfer toward
the rear.
(b) Lower the transmission with the transfer front and
remove it from the vehicle.
16. REMOVE ENGINE REAR MOUNTING
17. REMOVE PROPELLER SHAFT UPPER DUST COVER AND
TRANSFER FROM TRANSMISSION
(a) Remove the dust cover bolt from the bracket.
(b) Remove the transfer adapter rear mounting bolts.
(c) Pull the transfer straight up and remove it from the
transmission.
NOTE: Take care not to damage the adapter rear oil seal
' " -_ _ _ _ _ _ _ _ _ _ _ _ _ _ TF_Ol-.J
06
with the transfer input gear spline.