Toyota 4-Runner 1985 Repair Manual page 356

MANUAL TRANSMISSION - W46, 55 and 56 Transmission MT-25
WM0119
WM0120
WM0121
WM0122
5. INSTALL SECOND GEAR AND CLUTCH HUB NO.1
(a) Apply gear oil to the shaft and needle roller bearing.
(b) Place the synchronizer ring on the gear and align the
ring slots with the shifting keys.
(c) Install the needle roller bearing in the 2nd gear.
(d) Using a press, install the 2nd gear and clutch hub
No.1.
6. INSTALL LOCKING BALL AND FIRST GEAR ASSEMBLY
(a) Install the locking ball in the shaft.
(b) Apply gear oil to the bearing.
(c) Assemble the 1 st gear, synchronizer ring, needle roller
bearing and bearing inner race.
(d) Install the assembly on the output shaft with the syn-
chronizer ring slots aligned with the shifting keys and
turn the inner race to align it with the locking ball.
7 . INSTALL OUTPUT SHAFT CENTER BEARING
Using SST and a press, install the bearing on the output
shaft with the outer race snap ring groove toward the rear.
NOTE: Hold the 1 st gear inner race to prevent it from
falling.
SST 09506-35010