Toyota 4-Runner 1985 Repair Manual page 320

CH-14
Nippondenso
CHARGING SYSTEM - Alternator
CH0241
Borroughs
EC0003 EC0004 ECOOOl
CH0243
CH0242
INSTALLATION OF ALTERNATOR
1. INSTALL ALTERNATOR
Mount the alternator on the bracket with the pivot and ad-
just bolt.
2. INSTALL DRIVE BELT
(a) Place the drive belt on the alternator, fan and crank-
shaft pulleys.
(b) Using a belt tension gauge, check the drive belt
tension.
Belt tension gauge:
Nippondenso BTG-20 (95506-00020) or
Borroughs No. BT -33-73F
Drive belt tension:
New belt
Used belt
125
±
25 Ib
80
±
20
Ib
3. CONNECT WATER INLET HOSE
(a) Connect the water inlet hose to the engine.
(b) Install the two water inlet pipe bolts.
(c) Install the engine under cover.
4.
CONNECT WIRING TO ALTERNATOR
(a) Connect the wire to the alternator and install the nut.
(b) Connect the connector to the alternator.
5.
FILL WITH COOLANT
Close the radiator drain cock and fill with coolant.
6. CONNECT NEGATIVE CABLE TO BATTERY
7. PERFORM ON-VEHICLE INSPECTION
(See page
CH-3)