Toyota 4-Runner 1985 Repair Manual page 432

AT-30 AUTOMATIC TRANSMISSION - Disassembly of Transmission
/
8. REMOVE CONVERTER HOUSING
(a) Remove the two 12-mm bolts and four 1 O-mm
bol-::~
(b) While holding the input shaft, remove the
conve~
housing.
9. REMOVE EXTENSION HOUSING AND GASKET
10. REMOVE SPEEDOMETER DRIVE GEAR
11. REMOVE GOVERNOR BODY FROM OUTPUT SHAFT
(a) Loosen the staked part of the lock plate.
(b) Remove the governor body lock bolt.
(c) While lifting the retaining clip with alar "-
screwdriver, slide off the governor body.
12. IF NECESSARY, REMOVE GOVERNOR STRAINER
(a) Remove the four screws and plate.
(b) Remove the strainer from the case.
13. REMOVE PAN AND GASKET
(a) Remove the fourteen bolts.
(b) Remove the pan with lifting the transmission case.
CAUTION: Do not turn the transmission over as this will
contaminate the valve body with foreign materials in the
bottom of the pan.