Toyota 4-Runner 1985 Repair Manual page 504

AT-102
AUTOMATIC TRANSMISSION - Assembly of Transmission
(b) Align the cut part of the gasket and case.
Torque: 45 kg-em (39 in.-Ib, 4.4 Nom)
45. INSTALL DRAIN PLUG WITH NEW GASKET
Torque: 205
kg-em
(15 ft-Ib, 20
Nom)
46. INSTALL GOVERNOR LINE STRAINER
(a) Install the strainer onto the case.
(b) Install the plate.
47. INSTALL GOVERNOR BODY AND SPEEDOMETER DRIVE
GEAR ON OUTPUT SHAFT
(a) While lifting the retaining clip with a large screwdriver,
slide the governor body and insert the retaining (
end into the hole on the output shaft.
(b)
Install the lock plate and bolt, and then stake the lock
plate.
Torque: 40 kg-em (35 in.-Ib, 3.9 N·m)
(c) Install the snap ring and lock ball.
(d) Slide the speedometer gear on to the shaft.
(e) Using snap ring pliers, install the outer snap ring.
48. INSTALL EXTENSION HOUSING WITH NEW
GASKET
Do not use gasket sealer. Install the housing with four long
and two short bolts. Tighten the bolts.
Torque: 345 kg-em (25 ft-Ib, 34 Nom)
49. INSTALL SPEEDOMETER DRIVEN GEAR
50. INSTALL NEUTRAL START SWITCH AND SHIFT
HANDLE (See page AT-4)
51. INSTALL SOLENOID