Toyota 4-Runner 1985 Repair Manual page 435

AUTOMATIC TRANSMISSION - Disassembly of Transmission AT-33
~.. ~. ~
."
-
""'-
-
...
,.~:
25. REMOVE OVERDRIVE CLUTCH
Grasp the shaft and pull out the overdrive clutch assembly.
Watch for bearings and races on both sides of assembly.
26. REMOVE OVERDRIVE CASE AND BRAKE
Hold both sides of the overdrive case and pull it out from
the transmission case. Watch for bearings and races on
both sides of the assembly.
27.
MEASURE DISTANCE BETWEEN TOP OF CASE FLANGE
AND CLUTCH DRUM
Set SST in the case as shown in the figure.
SST 09350-20013
Make a note of the finding for reassembly.
28. REMOVE FRONT CLUTCH AND BEARINGS
Grasp the shaft and pull out the front clutch assembly.
Watch for bearings and races on both sides of the
assembly.
29. REMOVE BEARING AND RACE
30. REMOVE REAR CLUTCH
Grasp the clutch hub and pull it out from the case.