Toyota 4-Runner 1985 Repair Manual page 515

TF-8
TF0007 TFOOO8
TFOOO9 TFOO10
TRANSFER - Transfer
7. REMOVE REAR CASE
(a) Remove the ten bolts.
(b) Using a plastic hammer, remove the rear case
WI~
the idler gear.
NOTE: Hold the front case so the rear does not descend.
If it descends, the clutch hub and steel ball may fall out.
8. REMOVE IDLER GEAR FROM REAR CASE
(a) Using snap ring pliers, remove the snap ring.
(b) Using a plastic hammer, tap out the idler gear from
the rear case.
NOTE: Place the rear case on something soft such as
wooden blocks.
9. REMOVE BEARING RETAINER
~~
Remove the four bolts and remove the bearing retainer.
~ :'!(~;~\
,
-----;I(,~~
)~'\, \Il~~\
J~
1"0
\~~ (~:
/'/1) )~,:~~~\
/J(~J
!
<
TF0194
TF0195 TF0196
TFOO14
10. REMOVE FRONT DRIVE GEAR
(a) Using snap ring pliers, remove the snap ring.
(b) Using a plastic hammer, tap out the front drive gear
from the front case.
11. REMOVE OIL PIPES
Using pliers, remove the two oil pipes.