Toyota 4-Runner 1985 Repair Manual page 359

MT-28 MANUAL TRANSMISSION - W46, 55 and 56 Transmission
Front
16. (5-Speed)
WM0131
WM0132
WM0136
INSERT CLUTCH HUB NO.3 INTO HUB SLEEVE
(a) Install clutch hub No. 3 and the shifting key to .
hub sleeve.
(b) Install the shifting key springs under the shifting keys.
CAUTION: Install the key springs positioned so that their
end gaps are not in line.
(c) Using SST, install the shifting key retainer.
SST 09238-47012
17. (5-Speed)
INSTALL CLUTCH HUB NO.3
Using SST, drive in clutch hub No.3.
SST 09316-60010
NOTE: When installing the clutch hub, support the coun-
tershaft in front with a 3-5 Ib hammer or equivalent.
18. (5-Speed)
INSTALL SNAP RING
Select a snap ring that will allow minimum axial play and
install it on the shaft.
Mark Thickness
mm (in.)
2
2.06 - 2.11
(0.0811 - 0.0831)
3
2.12 - 2.17
(0.0835 - 0.0854)
4 2.18 - 2.23
(0.0858 - 0.0878)
5 2.24 - 2.29
(0.0882 - 0.0902)
19. (5-Speed)
INSTALL SPACER, SYNCHRONIZER RING, NEEDLE
ROLLER BEARING AND COUNTER FIFTH GEAR
(a) Install the bearing spacer.
(b) Apply gear oil to the needle roller bearings.
(c) Assemble the counter 5th gear, synchronizer ring
c.
needle roller bearings.