Toyota 4-Runner 1985 Repair Manual page 388

1 st
MANUAL TRANSMISSION - G 52 Transmission MT-57
GMOO65
3rd
2nd
GM0040
GM0066
GM0067
GM0068
7 . INSTALL OUTPUT SHAFT REAR BEARING
8.
9.
Using SST and a press, install the bearing on the output
shaft with the outer race snap ring groove toward the rear.
NOTE: Hold the 1 st gear inner race to prevent it from
falling.
SST 09506-35010
MEASURE FIRST AND SECOND GEAR THRUST
CLEARANCE
Using a feeler gauge, measure the 1 st and 2nd gear thrust
clearance.
Standard clearance:
0.10 - 0.25
mm
(0.0039 - 0.0098
in.)
Maximum clearance:
0.25 mm (0.0098 in.)
INST ALL FIFTH GEAR
Using SST and a press, install the 5th gear.
SST 09506-35010
10. INSTALL SNAP RING
(a) Select a snap ring that will allow minimum axial play.
(b) Using snap ring pliers, install the snap ring.
Mark
Tickness
mm (in.)
Mark Thickness mm (in.)
A 2.67 - 2.72 (0.1051 - 0.1071)
G
3.03 - 3.08 (0.1193 - 0.1213)
B
2.73 - 2.78 (0.1075 - 0.1094)
H 3.09 - 3.14 (0.1217 - 0.1236)
C
2.79 - 2.84 (0.1098 - 0.1118)
J
3.15 - 3.20 (0.1240 - 0.1260)
0 2.85 - 2.90 (0.1122 - 0.1142)
K 3.21 - 3.26 (0.1264 - 0.1283)
E
~.91 -
2.96 (0.1146 - 0.1165)
L 3.27 - 3.32 (0.1287 - 0.1307)
F
~.97 -
3.02 (0.1169 - 0.1189)