Toyota 4-Runner 1985 Repair Manual page 24

MA-14
MAINTENANCE - Maintenance Operations
Automatic TIM
MA0064
Add if cool
MA0099
RN2WD
SEE PAGE FA-7 to 9
RN4WD
SEE PAGE FA-44 to 47
Screw Plug
MAOOll
25. RN 2WD ONLY:
REPLACE AUTOMATIC TRANSMISSION FLUID
(a) Remove the drain plug and drain the fluid.
(b) Reinstall the drain plug securely.
(c)
With the engine OFF, add new fluid through the dip-
stick tube.
Fluid: ATF DEXRON®
n
Drain and refill capacity:
2.4 liters (2.5 US qts, 2.1 Imp. qts)
Dry fill capacity:
6.5 liters (6.9 US qts, 5.7 Imp. qts)
(d) Start the engine and shift the selector into all posi-
tions from P through L and then shift into P.
(e) With the engine idling, check the fluid level.
Add fluid up to the cool level on the dipstick.
CAUTION: Do not overfill.
26. REPACK FRONT WHEEL BEARINGS
Change the front wheel bearing grease.
RN 2WD - (See page FA-7 to 19)
RN 4WD - (See page FA-44 to 47)
RN 2WD -
Grease grade: Lithium base multipurpose grease
(NLGI No.2)
Wheel bearing friction preload (at starting):
0.6 - 1.8
kg
(1.3 - 4.0
Ib,
5.9 -
17.7
N)
RN 4WD -
Grease grade: Lithium base mUltipurpose grease
(NLGI No.2)
Wheel bearing friction preload (at starting):
2.8 - 5.6 kg (6.2 - 12.3 Ib, 27 - 55 N)
27. RN 4WD ONLY:
LUBE STEERING KNUCKLE AND CHASSIS
(Including propeller shaft)
(a) Remove the screw plug from each steering knuckle
and repack with lubricant.
Steering knuckle grease: Molybdenum disulphide lithiur
base grease (NLGI No.2)
(b) Reinstall the two screw plugs.