Replacement Of Engine Oil And Oil Filter - Toyota 4-Runner 1985 Repair Manual

LUBRICATION SYSTEM - Replacement of Engine Oil and Oil Filter LU-3
LU0004 LU0005
LU0006 LU0007
REPLACEMENT OF ENGINE OIL
AND OIL FILTER
1. DRAIN ENGINE OIL
Remove the oil drain plug and drain the oil into a container.
2. REPLACE OIL FILTER
(a) Using SST, remove the oil filter (located on right side
of the engine block).
SST
09228-44010
(b) Inspect and clean the oil filter installation surface.
(c) Apply clean engine oil to the gasket of the new oil
filter.
(d) Lightly screw in the oil filter to where you feel
resistance.
(e) Then, using SST, tighten the oil filter an extra 3/4 turn.
SST 09228-44010
3.
FILL WITH ENGINE OIL
(a) Clean and install the oil drain plug with a new gasket.
(b) Fill the engine with new oil API grade SF or SF/CC,
multigrade, fuel efficient and recommended viscosi-
tyoil.
Oil capacity:
Dry fill
Drain and refill
w/o Oil filter change
w / Oil filter change
4.8 liters
(5.1 US qts, 4.2 Imp. qts)
4.0 liters
(4.2 US qts, 3.5 Imp. qts)
4.6 liters
(4.9 US qts, 4.0 Imp. qts)
4. START ENGINE AND CHECK FOR LEAKS
5. RECHECK ENGINE OIL LEVEL
Recheck the engine oil level and refill as necessary.
NOTE: Insert the oil level guage with the curved tip point-
ed toward the engine.