Toyota 4-Runner 1985 Repair Manual page 95

EM-66 ENGINE MECHANICAL - Cylinder Block
POST INSTAllATION
1. CONNECT FOLLOWING WIRES:
(a)
Starter wire
(b)
Oil pressure switch wire
(c)
Vacuum switch wire
(d)
Thermo sensor wire
(e)
Injector wires
(f)
00 thermo switch wire (with AfT)
(g)
Water thermo sensor wire
(h)
Cold start injector time switch wire
2. INSTALL CHAMBER WITH THROTTLE BODY
(a)
Position a new gasket on the intake manifold.
~
(b)
Install the chamber with throttle body.
(c)
Install the four bolts.
(d)
Install the two nuts with a bond cable.
(e)
Connect the chamber and stay with a bolt.
(f)
Install the EGR valve to the chamber with two bolts.
3. CONNECT FOLLOWING WIRES:
(a)
Air valve wire
(b)
Throttle position sensor wire
(c)
Cold start injection wire
(d)
Ox sensor wire
4. CONNECT FOLLOWING PARTS:
(a)
BVSV hoses
(b)
Cold start injection pipe
(c)
Pressure regulator hose to the chamber
(d)
Air control valve hose to actuator
(e)
Water by-pass hose No.2 and No.3 to the throttle
body.
(f)
Air valve hose No.2 to the chamber
(g)
Air valve hose No.1 to the throttle body
(h)
EGR vacuum modulator hose
(i) Actuator hose (with cruise control )
(j)
EV AP hose (for canister)
(k)
Air control valve hoses
(I) Brake booster hose
)
(m) PCV hose No.1 and No.2
~-~~-
5. CONNECT CABLES TO BRACKET
Connect the accelerator cable and throttle cable for AfT
to the bracket.