Toyota 4-Runner 1985 Repair Manual page 92

ENGINE MECHANICAL - Cylinder Block
EM-63
-----------
5. INSTALL ROD BEARING CAPS
(a) Match the numbered cap with the numbered rod.
(b) Align the marks punched on the rod and cap and
tighten the cap nuts to specified torque alternately in
two or three passes.
Torque: 630 kg-em (46 ft-Ib, 62 Nom)
NOTE: After tightening the caps, check that the crank-
shaft rotates smoothly.
6. MEASURE ROD THRUST CLEARANCE
(See step 3 on page EM-52)
7. INSTALL OIL STRAINER
(a) Clean the oil screen.
(b) Place the oil screen gasket in place and install the oil
screen assembly with four bolts. Torque the bolts.
_____ T' Torque: 130 kg-em (9 ft-Ib, 13 Nom)
8. INSTALL REAR OIL SEAL RETAINER
9. INSTALL TIMING CHAIN (See page EM-44)
10. INSTALL OIL PAN (See step 11 on page EM-46)
11. INSTALL CYLINDER HEAD (See page EM-27)
12. REMOVE ENGINE STANDS
13. INSTALL REAR END PLATE
14. INSTALL FLYWHEEL OR DRIVE PLATE ON CRANKSHAFT
Install the flywheel or drive plate on the crankshaft with
the six bolts. Torque the bolts.
Torque: 1,100 kg-em (80 ft-Ib, 108 Nom)
15. INSTALL CLUTCH DISC AND COVER TO FLYWHEEL (for
MIT) (See page CL-9)