Toyota 4-Runner 1985 Repair Manual page 506

AT-104 AUTOMATIC TRANSMISSION - Installation of Transmission
81537
RIOOOS
RlOOO5
6. INSTALL GUIDE PIN IN TORQUE CONVERTER
7. ALIGN TRANSMISSION AT INSTALLATION
POSITIO~
CAUTION: Be careful not to tilt the transmission forward
because the torque converter could slide out.
(a) Align the guide pin with a drive plate hole.
(b) Align the two sleeves on the block with the converter
housing.
8. INSTALL CONVERTER HOUSING MOUNTING BOLTS
Install the filler tube bracket with the upper right-hand bolt
and tighten both bolts.
Torque: 650 kg-em (47 ft-Ib, 64 N·m)
9. INSTALL STARTER
10. INSTALL BOTH SIDE STIFFENER PLATES
11 . INSTALL SIX TORQUE CONVERTER BOLTS
(a) Remove the guide pin.
(b) Install the six bolts finger tight. Turn the crankshflft
to gain access.
(c) Tighten the bolts evenly.
Torque: 185 kg-em (13 ft-Ib, 18 N·m)
12. INSTALL SERVICE HOLE COVERS AT REAR OF ENGINE
13. JACK UP TRANSMISSION SLIGHTLY AND REMOVE
WOODEN PIECE BETWEEN ENGINE OIL PAN AND
MEMBER
14. INSTALL ENGINE REAR MOUNTING WITH BRACKET
(a) Install the engine rear mounting with bracket to the
member.
Torque: 130 kg-em (9 ft-Ib, 13 N·m)
(b) Lower the transmission and connect the mounting to
the extension housing.
Torque: 260 kg-em (19 ft-Ib, 25 N·m)
15. INSTALL OIL FILLER TUBE AND CONNECT EXHAUST PIPE
CLAMP
16. INSTALL ENGINE UNDER COVER
17. CONNECT OIL COOLER LINES
Torque: 350 kg-em (25 ft-Ib, 34 N ·m)