Toyota 4-Runner 1985 Repair Manual page 79

EM-50 ENGINE MECHANICAL - Cylinder Block
;-------------
11. DISCONNECT FOLLOWING PARTS:
(a)
Oil
pressure sender gauge wire
(b) Neutral start switch wire (with AfT)
(c) Back-up light switch wire
(d) Fuel hose
12. REMOVE INTERMEDIATE SHAFT
(a) Put alignment marks on the flanges.
(b) Remove the four bolts and nuts.
(c) Remove the two bolts holding the center support bear-
ing to the body.
(d) Pull the sleeve yoke from the transmission.
(e) Insert SST in the transmission to prevent oil leakage.
SST
09325-20010
13.
DISCONNECT SHIFT LINKAGE FROM SHIFT LEVER
(with AfT)
14. DISCONNECT SPEEDOMETER CABLE
CAUTION: Do not lose the felt dust protector and
washers.
15. PLACE JACK UNDER TRANSMISSION
Be sure to put a wooden block between the jack and the
transmission pan.
16. REMOVE ENGINE REAR MOUNTING BRACKET
(a) Remove the four bolts holding the bracket to the
member.
(b) Remove the four bolts holding the bracket to the
transmission and remove the bracket.
17. REMOVE ENGINE WITH TRANSMISSION FROM VEHICLE
(a) Attach the engine hoist chain to the lift brackets of
the engine.
(b) Lift the engine out of the vehicle slowly and carefully.
NOTE: Make sure the engine is clear of all wiring and
hoses.
18. REMOVE TRANSMISSION FROM ENGINE
(a) Remove the starter.
(b) Remove the two stiffener plates and exhaust pipe
bracket from engine.
(c) Remove the transmission from the engine.