Toyota 4-Runner 1985 Repair Manual page 378

MANUAL TRANSMISSION - G52 Transmission
MT-47
GM0036
GM0037
GM0039
3rd
1 st 2nd
GM0040
23. REMOVE BEARING SNAP RING
Using snap ring pliers, remove the snap ring.
24. REMOVE OUTPUT SHAFT, COUNTER GEAR AND INPUT
SHAFT AS A UNIT FROM INTERMEDIATE PLATE
(a) Remove the output shaft, counter gear and input shaft
as a unit from the intermediate plate by pulling on the
counter gear and tapping on the intermediate plate
with a plastic hammer.
(b) Remove the input shaft with the 14-needle roller bear-
ings from the output shaft.
25. REMOVE COUNTER REAR BEARING FROM
INTERMEDIATE PLATE
26. REMOVE SLEEVE FROM OUTPUT SHAFT
Using SST, remove the sleeve from the output shaft.
SST 09950-20015
27. MEASURE EACH GEAR THRUST CLEARANCE
Measure the thrust clearance of each gear.
Standard clearance: 0.10 - 0.25 mm
(0.0039 - 0.0098 in.)
Maximum clearance: 0.25 mm (0.0098 in.)