AT-18
AUTOMATIC TRANSMISSION -
On-Vehicle Repair
'Smm
(0.59 in.)
~6.5
mm (0.26 in.)
1
i----
68 mm
65 mm
(2.68 in.)
20 mm (2.56 in.)
(O.79i~j
!f-. _ _ _
'1Smm
--~.I
(4.53 in.)
AT0782
OR0009
OR0010
ON-VEHICLE REPAIR
REMOVAL OF VALVE BODY
1.
MAKE PLATE TO RETAIN ACCUMULATOR PISTONS
A retainer is helpful for holding accumulator pistons in the
case during removal and installation of the valve body. The
plate may be made from aluminum or plastic.
2.
CLEAN TRANSMISSION EXTERIOR
To help prevent contamination, clean the exterior of the
transmission.
3.
DRAIN TRANSMISSION FLUID
Remove the drain play and drain the fluid into a suitable
container.
4.
REMOVE OIL PAN, FILLER TUBE AND GASKET
CAUTION:
Some fluid will remain in the oil pan. Be careful
not to damage the filler tube and O-ring.
Remove all pan bolts, and carefully remove the p
assembly. Discard the gasket.
5.
REMOVE OIL TUBES
Pry up both tube ends with a large screwdriver and remove
the tubes.
6.
REMOVE OIL STRAINER AND GASKET
Remove the five bolts, retainer, oil strainer, and the gasket.
CAUTION:
Be careful as some oil will come out with the
filter.