Toyota 4-Runner 1985 Repair Manual page 56

~
. I .
ENGINE MECHANICAL - Cylinder Head
INSTALLATION OF CYLINDER HEAD
(See page EM-12)
1. APPLY SEALER TO CYLINDER BLOCK
EM-27
(a) Apply liquid sealer to two locations as shown.
(b) Place a new heac;i gasket over dowels on the cylinder
block.
2. INSTALL CYLINDER HEAD
(a) If the sprocket was removed, align the alignment
marks placed on the sprocket and chain during
removal.
(b) Position the cylinder head over dowels on the block.
3. INSTALL ROCKER ARM ASSEMBLY
(a) Place the rocker arm assembly over the dowels on the
cylinder head.
(b) Install and tighten the head bolts gradually in three
passes and in the sequence shown. Torque the bolts
on the final pass.
Torque: 800 kg-em (58 ft-Ib, 78 N -m)
4. INSTALL CHAIN COVER BOLT
Torque the bolt.
Torque: 130 kg-em (9 ft-Ib, 13 N-m)
5. INSTALL CAM SPROCKET ON CAMSHAFT
(a) Turn the camshaft to position the dowel at the top.