Toyota 4-Runner 1985 Repair Manual page 426

AT-24 AUTOMATIC TRANSMISSION - On-Vehicle Repair
81498
o
~
\ C3583
81500
C3584 B1498
8. REMOVE EXTENSION HOUSING AND GASKET
Remove six bolts. If necessary, tap the extension housir"
with a plastic hammer to loosen it.
9. REMOVE SPEEDOMETER DRIVE GEAR
(a) Using snap ring pliers, remove the snap ring.
(b) Slide off the speedometer gear.
(c) Remove the lock ball and the other snap ring.
1 O. REMOVE GOVERNOR FROM OUTPUT SHAFT
(a) Remove the lock plate and bolt.
(b) Using a larger screwdriver, lift the retaining clip on thp.
square side and slide the governor off the shaft.
INSPECTION AND REPAIR OF GOVERNOR
ASSEMBLY
(See page AT-91)
INSTALLATION OF GOVERNOR ASSEMBLY
1. INSTALL GOVERNOR ON OUTPUT SHAFT
(a) Using a large screwdriver, lift the retaining clip, and
slide the governor body onto the shaft with the re-
taining clip facing the end of the shaft.
(b) Insert the retaining clip into the hole in the output
shaft. Check that the governor assembly is secure.
(c) Install the lock plate and bolt.
2. INSTALL SPEEDOMETER DRIVE GEAR
(a) Install the snap ring and lock ball.
(b) Slide the speedometer gear on the shaft.
(c) Using snap ring pliers, install the outer snap ring.