Toyota 4-Runner 1985 Repair Manual page 351

MT-20
MANUAL TRANSMISSION - W46, 55 and 56 Transmission
WM0176
WMoon
WM0079
WM0078
WM0083
(e) Using a socket wrench, press in the bearing, side race
and inner race.
(f) Select a snap ring that will allow minimum axial play
and install it on the shaft.
Mark Thickness
mm (in.)
1 2.05 - 2.10
(0.0807 - 0.0827)
2 2.10 - 2.15
(0.0827 - 0.0846)
3
2.15 - 2.20 (0.0846 - 0.0866)
4 2.20 - 2.25 (0.0866 - 0.0886)
5 2.25 - 2.30
(0.0886 - 0.0906)
6 2.30 - 2.35 (0.0906 - 0.0925)
7 2.35 - 2.40
(0.0925 - 0.0945)
10. IF NECESSARY, REPLACE COUNTER GEAR CENTER
BEARING
(a) Remove the bearing from the counter gear.
(b) Install the new bearing on the counter gear.
NOTE: Engage the roller cages.
(c) Using SST, tap out the bearing outer race.
SST 09608-35013
NOTE: The outer race will be installed later, as the trans-
mission is assembled.
11. IF NECESSARY, REPLACE REVERSE RESTRICT PIN
(a) Using SST, remove the screw plug.
SST 09313-30021