Toyota 4-Runner 1985 Repair Manual page 463

AUTOMATIC TRANSMISSION - Component Groups (Planetary Gear Output Shaft)
2. REMOVE THRUST WASHER FROM PLANETARY
GEARS
AT-61
NOTE: The thrust washer may have stuck to the inside
of the planetary gear case.
3. REMOVE BRAKE DISCS AND PLATES FROM
PLANETARY GEARS
4. REMOVE REACTION PLATE FROM PLANETARY
GEARS
5. REMOVE SNAP RING AND ONE-WAY CLUTCH FROM
PLANETARY GEARS
6. REMOVE NYLON THRUST WASHER FROM PLANETARY
GEARS
7. REMOVE APPLY TUBE AND CLUTCH PRESSURE PLATE
8. COMPRESS SHAFT SNAP RING AND REMOVE FRONT
PLANETARY RING GEAR
(a) While pulling up the ring gear, compress the snap ring
with needle-nose pliers and remove it from the groove.
(b) Pull out the ring gear by hand.
9. REMOVE INTERMEDIATE SHAFT FROM OUTPUT SHAFT
ASSEMBLY
10. REMOVE THRUST BEARING AND RACES FROM
OUTPUT SHAFT ASSEMBLY
Note the position of the races.
11. REMOVE THREE OIL SEAL RINGS FROM OUTPUT SHAFT
12. REMOVE THRUST WASHER AND REAR PINION GEARS
FROM INTERMEDIATE SHAFT ASSEMBLY
13. REMOVE RACE AND THRUST BEARING FROM
INTERMEDIATE SHAFT
Note the position of the race.