Toyota 4-Runner 1985 Repair Manual page 231

FI-62
EFI SYSTEM - Air Intake System
O,,~
FI0606
(b) Insert a thickness gauge (0.47 mm or 0.0185 in.)
between the throttle stop screw and lever, and con-
nect the ohmmeter to terminals IDL and E
2 •
Gradually turn the sensor clockwise until the ohm-
meter deflects, and secure the sensor with two
screws.
(c) Using a thickness gauge, recheck the continuity be-
tween terminals IDL and E
2 •
Clearance between
Continuity (IDL - E
2 )
lever and stop screw
0.57 mm (0.0224 in.)
Continuity
0.85 mm (0.0335 in.) No continuity
INSTALLATION OF THROTTLE BODY
1. INSTALL THROTTLE BODY
Using new gaskets, install the throttle body and four
bolt~
2. CONNECT THROTTLE SENSOR CONNECTOR
3. CONNECT FOLLOWING HOSES:
(a) Emission control hoses
(b) PCV hose to throttle body
(c) No.1 and No.2 water by-pass hoses.
4. INSTALL AIR INTAKE CONNECTOR