Toyota 4-Runner 1985 Repair Manual page 306

STARTING SYSTEM -
Starter
ST-11
4. PERFORM NO-LOAD PERFORMANCE TEST
(a) Connect the battery and ammeter to the starter as
shown.
(b) Check that the starter rotates smoothly and steadily
with the pinion moving out. Check that the ammeter
reads the specified current.
Specified current: Less than 90 A at
11.5 V
INSTALLATION OF STARTER
1 . INSTALL STARTER MOTOR IN FLYWHEEL BELL-
HOUSING
Place the starter motor in the flywheel bellhousing.
Install and torque the two bolts.
Torque: 400 kg-cm (29
ft-Ib.
39 Nom)
2. CONNECT TWO WIRES TO STARTER
ST0004
Connect the connector to the terminal on the magnetic
~----------------------------~
switch. Connect the cable from the battery to the terminal
on the switch, and install the nut.
3. INSTALL TRANSMISSION OIL FILLER TUBE (AfT only)
4. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
Check that the car starts.