Toyota 4-Runner 1985 Repair Manual page 304

Bearing
Idle~~,~~.
w--
Clutch Assembly
Pinion Gear
Idle Gear
~ t;t
Bearing
Clutch Assembly
STARTING SYSTEM -
Starter ST-9
B1423
ST0026
ST0027
ST0007
ST0008
3. INSERT STEEL BALL INTO CLUTCH SHAFT HOLE
Apply grease to the ball and spring, and insert them into
the clutch shaft hole.
4. INSTALL GEARS AND CLUTCH ASSEMBLY TO
STARTER HOUSING
[1.0 kW
type]
(a) Apply grease to the gear and clutch assembly.
(b) Place the clutch assembly, idle gear and bearing in the
starter housing.
[1.4 kW
type]
(a) Apply grease to the gears and clutch assembly.
(b) Place the clutch assembly, idle gear, bearing and pi-
nion gear in the starter housing.
5. INSTALL STARTER HOUSING
(a) Insert the spring into the clutch shaft hole.
(b) Place the starter housing on the magnetic switch and
install the two screws.