Toyota 4-Runner 1985 Repair Manual page 318

CH-12
CHARGING SYSTEM - Alternator
CH0218
ASSEMBLY OF ALTERNATOR
(See page CH-6)
1. INSTALL ROTOR TO DRIVE END FRAME
2. INSTALL REAR END FRAME
(a) Using a plastic hammer, lightly tap the rear end frame
on the drive end frame.
(b) Install the four nuts.
3. INSTALL PULLEY
(a) Install the pulley to the rotor shaft by tightening the
pulley nut by hand.
(b) Hold SST
I I
A" with a torque wrench and tighten SST
"8" clockwise to the specified torque.
SST 09820-63010
Torque: 400 kg-em (29 ft-Ib, 39 N ·m)
(c) Confirm that SST
I I
A" is secured to the pulley shaft.
CH0236
(d) As shown in the figure, grip SST
lie"
in a vise and
' - - - - -_ _ _ _ _ _ _ _ _ _ _ ----l
then install the alternator to SST
lie".
/
/
CH0062
CHOl88
(e) To torque the pulley nut turn SST
I I
A" in the direc-
tion shown in the figure.
Torque: 950 - 1,300 kg-em
(69 - 94 ft-Ib, 94 - 127 N·m)
(f) Turn SST "8" and remove all SSTs.
4. INSTALL FOUR TERMINAL INSULATORS
Install the four terminal insulators on the lead wires.
5. INSTALL RECTIFIER HOLDER
Install the rectifier holder with the four screws.