Toyota 4-Runner 1985 Repair Manual page 421

\
/
AUTOMATIC TRANSMISSION - On-Vehicle Repair AT-19
OR0012
81485
OR0006
7. REMOVE VALVE BODY
(a) Remove the seventeen bolts.
NOTE: Bolt lengths will be shown for installation, so there
is no need to mark them now.
(b) Lower the valve body slightly, and install the ac-
cumulator piston retaining plate. Hold it in place with
two pan bolts. Hand tighten the bolts with a socket
driver.
(c) Disconnect the throttle cable from the cam and
remove the valve body.
DISASSEMBLY, INSPECTION AND
ASSEMBLY OF VALVE BODY
(See page AT-29)
INSTALLATION OF VALVE BODY
1. CONNECT THROTTLE CABLE TO CAM
Push the cable fitting into the cam.
2. ALiGH MANUAL VALVE LEVER WITH MANUAL VALVE
AND LOOSELY INSTALL SEVERAL BOLTS IN VALVE
BODY
Leave the bolts loose so that the accumulator retaining plate
can be removed.
3. REMOVE ACCUMULATOR RETAINING PLATE
Remove the two pan bolts, and slide out the plate.