Toyota 4-Runner 1985 Repair Manual page 45

EM-16
ENGINE MECHANICAL - Cylinder Head
5. REMOVE CHAIN COVER BOLT
/ Remove the bolt in front of the head before the other head
7
9
6
4
Front'"
3
10 8
2
bolts are removed.
6. REMOVE CYLINDER HEAD BOL TS
Remove the head bolts gradually in two or three passes
and in the numerical order shown.
CAUTION: Head warpage or cracking could result from
removing in incorrect order.
7. REMOVE ROCKER ARM ASSEMBLY
It may be necessary to use a pry bar on the front and rear
of the rocker arm assembly to separate it from the head.
8. REMOVE CYLINDER HEAD
Lift the cylinder head from the dowels on the cylinder block
and place the head on wooden blocks on a bench.
NOTE: If the cylinder head is difficult to lift off, pry with
a screwdriver between the head and block saliences.
CAUTION: Be careful not· to damage the cylinder head
and block surfaces of the cylinder head gasket side.