Toyota 4-Runner 1985 Repair Manual page 75

EM-46 ENGINE MECHANICAL -
Timing Chain
Seal
width approx.
5 mm (0.20 in.)
. r:=
Groove
Inside of hole
LJ
EM0845
.f7U
5
mm
(0.20
in.)
EM0847
LU0099
10. INSTALL OIL PAN
(a) Remove any old packing material and be careful
1"11
to drop any oil on the contacting surfaces of the
pan and cylinder block.
• Using a razor blade and gasket scraper, remove all
the packing (FIPG) material from the gasket sur-
faces.
• Thoroughly clean all components to remove all the
loose material.
• Clean both sealing surfaces with a non-residue
solvent.
CAUTION: Do not use a solvent which will affect the
painted surfaces.
(b) Apply liquid sealer to the joint part of the cylinder block
and chain cover, cylinder block and rear oil seal re-
tainer.
(c) Apply No.1 02 seal packing (Part No. 08826-00080
or equivalent to the oil pan as shown in the figure.
• Install a nozzle that has been cut to a 5-mm (0.20
in.) opening .
NOTE: Avoid applying an excess amount to the surface.
Be especially careful near oil passages.
• Parts must be assembled within 5 minutes of ap-
plication. Otherwise, the material must be removed
and re-applied.
• Immediately remove nozzle from tube and reinstall
cap.
(d) Install the oil pan over the studs on the block with six-
teen bolts and two nuts. Torque the bolts and nuts.
Torque: 130 kg-cm (9 ft-Ib, 13 Nom)
(e) Lower the engine and install the engine mounting
bolts.
(f) Intall the engine under cover.
POST INST ALLATI'ON
11. INSTALL RADIATOR (See page CO-12)
12. INSTALL CYLINDER HEAD
(22R-E See page EM-25)
(22R See page EM-36)