Toyota 4-Runner 1985 Repair Manual page 383

MT-52
MANUAL TRANSMISSION - G 52 Transmission
WM0067
WMOO68
WM0069
WM0070
WM0071
6. IF NECESSARY, REPLACE INPUT SHAFT BEARING
(a) Using snap ring pliers, remove the snap ring.
(b) Using a press, remove the bearing.
(c) Using a press and SST, install a new bearing.
SST 09506-35010
(d) Select a snap ring that will allow minimum axial play
and install it on the shaft.
Mark Thickness
mm (in.)
0 2.05 - 2.10 (0.0807 - 0.0827)
1 2.10 - 2.15
(0.0827 - 0.0846)
2 2.15 - 2.20 (0.0846 - 0.0866)
3 2.20 - 2.25
(0.0866 - 0.0886)
4 2.25 - 2.30 (0.0886 - 0.0906)
5 2.30 - 2.35 (0.0906 - 0.0925)
7.
INSPECT FRONT BEARING RETAINER
Check the retainer and oil seal for wear or damage. If the
oil seal is worn or damaged, replace it as follows.
(a) Using a screwdriver, pry out the oil seal.