Toyota 4-Runner 1985 Repair Manual page 487

AUTOMATIC TRANSMISSION - Component Groups (Valve Body) AT-85
ASSEMBLY OF UPPER REAR VALVE BODY
{See page AT-82l
1.
2.
INSTALL DETENT REGULATOR VALVE, SPRING AND
RETAINER
Insert the valve (round end first)and spring into the bore.
Compress the spring with a large screwdriver and slip the
retainer over the edge of the spring. Then compress the
spring and allow the retainer to fall into place.
NOTE: Make sure that the retainer fully covers the end
of the spring.
INSERT INTERMEDIATE MODULATOR VALVE AND
SPRING
Insert the valve with round end first, and then insert the
spring.
3. INSTALL VALVE BODY SIDE COVER WITH ONE BOLT
4. INSERT REAR CLUTCH SEQUENCE VALVE AND SPRING
Insert the valve with the round end first. Then insert the
spring.
5.
6.
7.
INSERT GOVERNOR MODULATOR VALVE AND SPRING
Insert the valve with the round end first. Then insert the
spring.
INSERT LOW MODULATOR VALVE AND SPRING
Insert the valve with the round end first. Then insert the
spring.
POSITION COVER AND INSTALL SECOND BOLT
Install the 2nd bolt, and tighten both bolts.
Torque: 55 kg-em (48 in.-Ib, 5.4 Nom)