FU-16
Coil Housing
FUEL SYSTEM -
Carburetor
;.;;r---( 1)
181---(2)
1~---!......,;,.---(3)
4)
FU0262
Fuel Cut (-)
5.
ASSEMBLE AIR HORN AND BODY
(a)
Put a new gasket on the body.
6.
(b)
Carefully assemble the air horn and body.
INSTALL FIVE SCREWS WITH OTHER PARTS AS
FOLLOWS:
(a)
(b)
(c)
Install the fuel inlet bracket (1).
Instal the number plate (2).
Install the VCV clamp (3) and wire clamp (4).
(d)
Connect the fast idle link.
7.
INSTALL METERING NEEDLE
(a)
Install the metering needle with a collar.
(b)
Hook the spring end into the hole.
(c)
Insert a washer and tighten the screw.
8.
INSTALL TERMINAL TO CONNECTOR
(a)
Push in the terminal until it is securely locked in the
connector lug.
(b)
Pull on the wire to confirm that it is securely locked.