Toyota 4-Runner 1985 Repair Manual page 424

AT-22
SST
AUTOMATIC TRANSMISSION - On-Vehicle Repair
OR001a OR0019
OROO17
ORoo04
OROOOS
REMOVAL OF PARKING LOCK PAWL
1. REMOVE VALVE BODY (See page
AT-18)
2. REMOVE PARKING LOCK PAWL BRACKET
Remove the two bolts and the bracket.
3. REMOVE SPRING FROM PARKING LOCK PAWL PIVOT PIN
4. REMOVE PIVOT PIN AND PARKING LOCK PAWL
INSTALLATION OF PARKING LOCK PAWL
1. INSTALL PARKING LOCK PAWL AND PIVOT PIN
2. INSTALL PIVOT SPRING
3. INSTALL PARKING LOCK PAWL BRACKET
(a) Push the lock rod fully forward.
(b) Install the two bolts finger tight.
(c) Check that the pawl operates smoothly.
(d) Torque the bolts.
Torque: 75 kg-em (65 in.-Ib, 7.4 N·m)
4. INSTALL VALVE BODY (See page AT-19)
REPLACEMENT OF REAR OIL SEAL
1.
RAISE VEHICLE, AND POSITION PAN TO CATCH ANY
FLUID THAT MAY DRIP
2.
REMOVE PROPELLER SHAFT
3. REMOVE REAR DUST SEAL AND OIL SEAL
CAUTION:
Clean the rear extension housing before
removing the seal.
U sing SST, remove the two seals.
SST 09308-10010
4.
INSTALL NEW OIL SEAL AND DUST SEAL
Using SST, drive in the oil seal as far as it will go. Drive
in the dust seal flush with the housing.
SST 09325-20010
5. INSTALL PROPELLER SHAFT
6.
LOWER VEHICLE AND CHECK FLUID LEVEL
(See page MA-19)
Add fluid as necessary.
Fluid type: ATF DEXRON
n
CAUTION:
Do not overfill.