Toyota 4-Runner 1985 Repair Manual page 499

SST
AUTOMATIC TRANSMISSION - Assembly of Transmission AT-97
18. INSTALL THRUST WASHER ON OVERDRIVE CASE END
Coat the thrust washer with petroleum jelly and set it into
place, facing the lip side toward the overdrive case.
19. INSERT OVERDRIVE CASE INTO TRANSMISSION CASE
Insert the overdrive case gently through the two guide pins
with the circled part in the figure facing in the direction
indicated.
20. INSTALL THRUST WASHER
Coat the thrust washers with petroleum jelly. Install the
thrust washer on the overdrive planetary carrier.
NOTE: The washer lugs should be inserted in the holes.
21 . INSTALL OVERDRIVE CLUTCH IN CASE
Align of discs the flukes in the overdrive case. Align the
flukes with the slots of the overdrive clutch and press the
overdrive clutch into the overdrive case.
CAUTION: Be careful that the thrust washer does not fall
out.
22. CHECK CORRECT INSTALLATION OF OVERDRIVE
CLUTCH
Set SST on the overdrive case as shown in the figure.
Measure the distance between the top surface of SST and
overdrive clutch. If the distance corresponds to that dur-
ing disassembly, the overdrive clutch is installed correctly.
SST 09350-20013
Height: Measured value minus SST width
=
(Others) Approx. 3.5 mm (0.138 in.)