Atf Inspection; Adjustments - Toyota 4-Runner 1985 Repair Manual

AT-4 AUTOMATIC TRANSMISSION - A TF Inspection, Adjustments
WH EN TH ROTTlE VALVE IS
FUllY OPENED
MA0156
Outer Cable
Rubber Boot
Cable Stopper
(or Painted Mark)
M1400
A TF INSPECTION
1. CHECK FLUID LEVEL (See page MA-19)
2. CHECK FLUID CONDITION
If the A TF smells burnt or is black, replace it.
3. REPLACE ATF (See page MA-14)
ADJUSTMENTS
ADJUSTMENT OF THROTTLE CABLE
1. DEPRESS ACCELERATOR PEDAL ALL THE WAY AND
CHECK THAT THROTTLE VALVE OPENS FULLY
If the throttle valve does not open fully, adjust the acceler-
ator link.
2. FULLY DEPRESS ACCELERATOR
3. LOOSEN ADJUSTMENT NUTS
4. ADJUST THROTTLE CABLE
(a) Adjust the cable housing so that the distance between
the end of the boot and the stopper on the cable is
correct.
Distance: 0 - 1 mm (0 - 0.04 in.)
(b) Tighten the adjusting nuts.
(c) Recheck the adjustments.
ADJUSTMENT OF FLOOR SHIFT LINKAGE
ADJUST SHIFT LINKAGE
(a) Loosen the nut on the shift linkage.
(b) Push the manual lever fully rearward.
(c) Return the lever two notches to the NEUTRAL po-
sition.
(d) Set the shift selector in "N".
(e) While holding the selector lightly toward the "R"
range side, tighten the shift linkage nut.
ADJUSTMENT OF NEUTRAL START SWITCH
If the engine will start with the shift selector in any range
other than "N" or "P", adjustment is required.
' - -_ _ _ _ _ _ _ _ _ _ _ _ _ B1_45-.J3
1. LOOSEN NEUTRAL START SWITCH BOLT AND SET SHIFT
2.
Bolt
~---'-- Neutral Basic
Line
Groove
3.
Z1088
SELECTOR IN "N" RANGE
ADJUST NEUTRAL START SWITCH
(a) Disconnect the neutral start switch connector.
(b) Connect the ohmmeter between the terminals.
(c) Adjust the switch to the point where there is continui-
ty between Nand B terminals.
(d) Connect the neutral start switch connector.
TORQUE NEUTRAL START SWITCH BOLT
Torque: 55 kg-em (48 in.-Ib, 5.4 N·m)