Toyota 4-Runner 1985 Repair Manual page 60

ENGINE MECHANICAL - Cylinder Head EM-31
9.
CONNECT FOLLOWING PARTS:
(a)
BVSV hoses
(b)
Cold start injection pipe
(c)
Pressure regulator hose to the chamber.
(d)
Air control valve hose to the actuator
(e)
Water by-pass hoses No.2 and No.3 from
the throttle body.
(f)
Air valve hose No.2 to the chamber
(g)
Air valve hose No.1 to the throttle body
(h)
EGR vacuum modulator hose
(i) Actuater hose (with cruise control)
(j)
EVAP hose (to canister)
(k)
Air control valve hoses
(I)
Brake booster hose
(m) PCV hoses No.1 and No.2
10. CONNECT BOND CABLE OF REAR SIDE
11. CONNECT ACCELERATOR CABLE
Connect the accelerator cable and throttle cable for AfT
to the bracket.
12. CONNECT TWO HEATER HOSES
13. CONNECT RADIATOR UPPER HOSE FOR THERMOSTAT
HOUSING
14. CONNECT EXHAUST PIPE TO EXHAUST MANIFOLD
(a) Connect the exhaust pipe and exhaust manifold with
the three bolts.
(b) Connect the Ox sensor wire.
15. INSTALL AIR CLEANER HOSE
16. INSTALL DISTRIBUTOR AND SPARK PLUGS, AND SET
TIMING (See page IG-10)
17. FILL WITH ENGINE OIL
Fill the engine with new oil, API grade SF or SFfCC multi-
grade, fuel efficient, and recommended viscosity oil.
Oil capacity:
Dry
fill
4.8 liters
(5.1 US
qts,
4.2 Imp.
qts)
Drain and refill
w/o Oil filter change 4.0 liters
(4.2 US qts, 3.5 Imp. qts)
w / Oil filter change 4.6 liters
(4.9
US
qts, 4.0
Imp.
qts)