Toyota 4-Runner 1985 Repair Manual page 249

FU-6
FUEL SYSTEM - Carburetor
Lug
j*~
Wire
FU0262
FU0264 FU0263
DISASSEMBLY OF CARBURETOR
(See page FU-4)
The following instructions are organized so that you worK
on only one component group at a time. This will help avoid
confusion from similar looking parts from different sub-
assemblies being on your workbench at the same time.
(a) To facilitate reassembly, arrange parts in order.
(b) Be careful not to mix up or lose clips or springs.
(c) Use SST (Carburetor Driver Set).
SST 09860-11011
Disassembly of Air Horn
(See page FU-4)
1. DISCONNECT TERMINAL FROM CONNECTOR
Pry up the locking lugs with a screwdriver and pull out the
terminals.
2. REMOVE METERING NEEDLE
Loosen the screw and remove the metering needle.
3. REMOVE AIR HORN ASSEMBLY
(a) Disconnect the fast idle link and air valve connecting
rod.
(b) Remove the five air horn screws and lift the air horn
from the body.
(c) Remove the air horn -gasket.
4. REMOVE FLOAT AND NEEDLE VALVE
(a) Remove the pivot pin and float with the needle valve.
(b) Remove the needle valve seat.