Toyota 4-Runner 1985 Repair Manual page 345

MT-14
MANUAL TRANSMISSION - W46, 55 and 56 Transmission
13. (5-Speed)
REMOVE OUTPUT SHAFT REAR BEARING AND FIFTH
GEAR
(a) Using two screwdrivers and a hammer, tap out the
snap ring.
(b) Using SST, remove the rear bearing and 5th gear.
SST 09312-20011
14. REMOVE REVERSE GEAR
(a) Using snap ring pliers, remove the snap ring.
(b) Using SST, remove the reverse gear.
SST
09950-20015
15. REMOVE CENTER BEARING RETAINER
(a) Using a torx socket wrench, unscrew the torx screws
and remove the retainer.
(b) Using snap pliers, remove the snap ring.
16. REMOVE OUTPUT SHAFT AND COUNTER GEAR AS A
UNIT FROM INTERMEDIATE PLATE
(a) Remove the output shaft, input shaft and counter gear
as a unit from the intermediate plate by pulling on the
counter gear and tapping on the intermediate plate
with a plastic hammer.
(b) Remove the input shaft from output shaft.
17. MEASURE EACH GEAR THRUST CLEARANCE
Using a feeler gauge, measure the thrust clearance of each
gear.
Standard clearance:
Maximum clearance:
0.10 - 0.25 mm
(0.0039 - 0.0098 in.)
0.30 mm (0.0118 in.)