Toyota 4-Runner 1985 Repair Manual page 358

MANUAL TRANSMISSION - W46, 55 and 56 Transmission MT-27
WM0126
WM0127
11. INSTALL BEARING RETAINER
(a) Using snap ring pliers, install the bearing snap ring.
NOTE:
Be sure the snap ring is flush with the intermedi-
ate plate surface.
(b)
Using a torx socket wrench, tighten the screws.
Torque: 130 kg-em (9 ft-Ib, 13 Nom)
12. INSTALL REVERSE GEAR
Using SST, install the reverse gear.
SST 09312-20011
13. INSTALL SNAP RING
Select a snap ring that will allow minimum axial play and
install it on the shaft.
Mark Thickness mm (in.) Mark Thickness mm(in.)
5 2.25-2.30 (0.0886-0.0906) 17 2.61-2.66 (0.1028-0.1047)
11 2.30-2.35 (0.0906-0.0925) 18 2.67-2.72 (0.1051-0.1071)
12 2.35-2.40 (0.0925-0.0945) 19 2.73-2.78 (0.1075-0.1094)
13 2.40-2.45 (0.0945-0.0965) 20 2.79-2.84 (0.1098-0.1118)
14 2.45-2.50 (0.0965-0.0984) 21 2.85-2.90 (0.1122-0.1142)
15 2.50-2.55 (0.0984-0.1004) 22 2.91-2.96 (0.1146-0.1165)
16 2.55-2.60 (0.1004-0.1024) 23 2.97-3.02 (0.1169-0.1189)
14. (5-Speed)
INSTALL FIFTH GEAR AND OUTPUT SHAFT REAR
BEARING
Using SST, install the 5th gear and rear bearing.
SST 09312-20011
15. (5-Speed)
INSTALL SNAP RING
Select a snap ring that will allow minimum axial play and
install it on the shaft.
Mark Thickness mm (in.)
Mark
Thickness
mm (in.)
8 2.31-2.36 (0.0909-0.0929) 12 2.55-2.60 (0.1004-0.1024)
9
2.37 -2.42 (0.0933-0.0953) 13 2.61-2.66 (0.1028-0.1047)
10 2.43-2.48 (0.0957-0.0976) 14 2.68-2.73 (0.1055-0.1075)
11 2.49-2.54 (0.0980-0.1000) 15 2.74-2.79 (0.1079-0.1098)