Toyota 4-Runner 1985 Repair Manual page 496

AT-94
AUTOMATIC TRANSMISSION - Assembly of Transmission
1. PLACE TRANSMISSION CASE ON CYLINDER
2.
Place the transmission on a cylindrical stand for more ef4=i-
cient work.
CAUTION: Place shop rags between the case and stand
to avoid damaging the case.
INSTALL THRUST WASHER AND BEARING
Install the thrust washer, facing the cup side downward.
3. INSTALL APPLY TUBE ONTO OUTER PISTON OF REAR
BRAKE PISTONS
Install the tube, aligning its locking tab (part A) with part
B of the case.
NOTE: Make sure that the lips of the tube end are com-
pletely inserted onto the outer piston.
4. PARTIALLY INSERT OUTPUT SHAFT ASSEMBLY INTO
CASE
5. CHECK CLUTCH PACK CLEARANCE
With the case in upright position, make sure that the clutch
Groove
pack is lower than the ledge below the snap ring groove.
ATOO16
If the clutch pack is not lower than the ledge, components
may be misassembled or there may be excess ATF on the
discs.
Standard clearance:
0.61 - 2.64 mm
(0.0240 - 0.1039 in.)