Toyota 4-Runner 1985 Repair Manual page 423

Pull lightly
Rubber Boot
AUTOMATIC TRANSMISSION - On-Vehicle Repair
AT-21
ORQO07
OR0016 C3579
Outer Cable
OR002l
OR0007
REMOVAL OF THROTTLE CABLE
1. DISCONNECT THROTTLE CABLE
(a) Disconnect the cable housing from the bracket.
(b) Disconnect the cable from the carburetor linkage.
2. REMOVE VALVE BODY (See page AT-18)
3. PUSH THROTTLE CABLE OUT OF TRANSMISSION CASE
Using a 10- mm socket, push the throttle cable out.
INSTALLATION OF THROTTLE CABLE
1 . INSTALL CABLE IN TRANSMISSION CASE
Be sure to push it in all the way.
2. INSTALL VALVE BODY (See page AT-19)
3.
IF THROTTLE CABLE IS NEW, PAINT MARK ON INNER
CABLE
NOTE: New cables do not have a cable stopper installed.
Therefore, to make adjustment possible, paint a mark as
described below.
(a) Pull the inner cable lightly until a slight resistance is
felt, and hold it.
(b) Paint a mark as shown, about 4 mm (0.16 in.) in
width.
4. CONNECT THROTTLE CABLE
(a) Connect the cable to the carburetor linkage.
(b) Connect the cable housing to the bracket.
5. ADJUST THROTTLE CABLE (See page AT-4)
6. TEST DRIVE VEHICLE