Toyota 4-Runner 1985 Repair Manual page 313

CHARGING SYSTEM - Alternator
CH-7
CH0061
SSTII:®" .
SST
"B"
I ..
CH0236
CH0235 CH0237
3. REMOVE IC REGULATOR
Remove the three screws and
IC
regulator.
4. REMOVE RECTIFIER HOLDER
Remove the four screws and rectifier holder.
5. REMOVE TERMINAL INSULATOR
6. REMOVE PULLEY
(a) Hold SST
I I
A" with a torque wrench and tighten SST
liB" clockwise to the specified torque.
SST
09820-63010
Torque: 400 kg-em (29 ft-Ib, 39 Nom)
(b) Confirm that SST
I I
A" is secured to the pulley shaft.
(c) As shown in the figure, grip SST "C" in a vise and
then install the alternator to SST
lie".
(d) To loosen the pulley nut turn SST
I I
A" in the direc-
tion shown in the figure.
CAUTION: To prevent damage to the rotor shaft, do not
loosen the pulley nut more than one-half of a turn.
(e) Turn SST
"B"
and remove all SSTs.
(f) Remove the pulley nut and the pulley.